Skip to main content

Tonnage

Curated by Valerius • Rivets, Regulations and the Sinking of RMS Titanic

Definition

A volumetric measure of a ship's carrying capacity used under 1894 regulations to calculate lifeboat capacity rather than actual passenger manifest counts.

In Context

The sheer scale of casualties stemmed directly from a bureaucratic failure enacted nearly two decades earlier. Under the Merchant Shipping Act of 1894, the British Board of Trade governed maritime safety regulations. At that time, the largest vessel afloat measured roughly 12,900 tons. Regulators calculated required lifeboat capacity based on a ship's cubic tonnage rather than its maximum passenger manifest.

Primary Source

Rivets, Regulations and the Sinking of RMS Titanic

An analysis of how 19th-century metallurgy and bureaucratic negligence failed to withstand the physical realities of the freezing Atlantic. Uncapped bulkheads, brittle iron rivets, and outdated lifeboat regulations guaranteed the destruction of the ocean liner long before it struck the ice.

Read Study (17 min) →

Artifacts

Glossary

wrought iron rivets
High-slag fasteners used in the manually riveted bow and stern sections of the hull, which became brittle and sheared in sub-zero water.
transverse bulkheads
The vertical watertight steel partitions inside the Titanic's hull designed to compartmentalize flooding, which fatally stopped short at E Deck.
e deck
The vertical ceiling limit for many of the Titanic's watertight bulkheads, allowing water to overtop and cascade from one compartment to the next.
welin davits
The modern double-acting mechanical arms on the Boat Deck capable of lowering up to three rows of lifeboats, which were launched mostly empty.
slag
A glassy silicate byproduct of smelting, which in excessive amounts made the Titanic's manually forged wrought iron rivets prone to brittle fractures in cold water.